Thingiverse
Electroplating Wand
por Kickbut101
21
Descargas
13
Likes
0
Makes
Wand for electroplating. Snake a wire through the center and wrap it around the notches on the spatula. Throw some tinfoil wrapped a few times around the spatula (over the top of the wire) and then apply the cotton strips and a rubber band. Voila all good to go.
I printed it laying down with support to hold the spatula up. How I have it sitting on my table in the picture is how I printed it.
I printed it laying down with support to hold the spatula up. How I have it sitting on my table in the picture is how I printed it.
Kickbut101 también publica en
62 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!