Elegoo Centauri Carbon Low Riser Remix

I am space limited due to a shelf above the Centauri and I plan to use it primarily for ABS / ASA prints so I sliced off the vents but retained the angled shelf to add in led light strips. The Centauri Carbon is dark inside! I added 2 extra longer pieces to the file, not sure if I had ABS cooldown shrinkage or if the glass on my ECC was sized slightly different. YMMV. Printed in Overture ABS Diamond Gray, definitely fits the aesthetic. 6.5ft LED light strip from Amazon was installed and cut to length. ***The channel on the back right piece for the power wire to pass thru could stand to be bit deeper if you aren't going to use thin weather stripping between the riser and the printer case to seal off abs/asa fumes***