elegoo centauri carbon sliding riser

Hi allThis is my Remix of the elegoo centauri carbon sliding riser by CCraft3Dhttps://makerworld.com/en/models/1381216-ele-goo-centauri-carbon-sliding-riser I have cut it into for parts for those of us with smaller build plates Like the Bambu A1, added vents along all sides & created 4 slots for dowels to fit in, these dowels are friction fit so are Very Tight & need no glue. I had to very gently tap them down & they went in grate. Also added clips / hooks so that if you run an LED strip around it there is no chance of the glue on them coming loose and the LED falling on to your build plate.Supports are needed for the clips / hooks. Some of the settings I used.For the sparse infill I set the sparse infill density to 10%sparse infill pattern to GyroidFilament used is Elegoo Rapid PLA+ LED Strip lights From UK Amazonhttps://www.amazon.co.uk/dp/B0DZBGFYMN?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1 This was all done with Fusion 360 & Tinkercad; this is also my very first post to Makerworld so