Thingiverse
Elegoo Jupiter automatic bottlecap
door J_Schmidt
0
Downloads
1
Likes
0
Makes
My version of a Elegoo Jupiter compatible automatic bottle cap. Is compatible to the automatic refill port on the elegoo Jupiter, and suitable for thicker resin than the original caps, that have a very small opening, leading to vacuum inside the bottle.
My version doesn´t need an o-ring or rubber seal, due it seals through a taper. But you´ll need to keep it nice and tidy!
Use a M5x20 screw for the inner guide, and a small spring if needed.
There´s also a higher version. If the screw interferes with the spring, use "Kappe_high" instead. Also, use a M5x25mm then.
Not for commercial use.
My version doesn´t need an o-ring or rubber seal, due it seals through a taper. But you´ll need to keep it nice and tidy!
Use a M5x20 screw for the inner guide, and a small spring if needed.
There´s also a higher version. If the screw interferes with the spring, use "Kappe_high" instead. Also, use a M5x25mm then.
Not for commercial use.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
