Elegoo Jupiter print platform drip / drain hook

This is a hook to add to your Elegoo Jupiter to give you a place to hang the build platform over the resin vat to let it drip itself dry after a print run. It attaches to the locating rods at the back of the platform

You'll need 2 M5x15-20mm screws and 2 M5 nuts to clamp it onto the rods.

Note: The right side of the bracket has a round hole for the locating rod, and the left side is a slot. This gives a little adjustability to prevent things from binding up. Make sure to tighten the right side first, and then the left side.