Elegoo Mars Heater - Non Destructive riser

Decided i wanted to add a heater to my elegoo mars to print some Blu resin (requires 25c minimum) and i did not want to drill a hole in my acrylic cover which would let the fumes out when i was printing normal resins, so i came up with this idea. The lid just sits on top of this piece giving room for the cable clip to slid in and allow destruction-less access for the power and temperature sensor. Any filament is good enough, it doesnt get hot enough for any melting concerns. PLA is fine.

The cable clip is designed only to be used with these 2 products below, although they are pretty common for DIY heaters for the mars in the first place. You could just not use the cable clip if you wanted to.

Used with nofear72784's Elegoo Mars / Enclosure Heater Bracket
https://www.thingiverse.com/thing:3786933

Heater used($15.99):
https://www.amazon.com/gp/product/B07573FKSG/ref=ppx_yo_dt_b_search_asin_image?ie=UTF8&psc=1

Temperature sensor used($17.99):
https://www.amazon.com/gp/prod