Elena

Elena is a survivor, a mechanic, and a fierce protector of her hometown. In a world where modern cities have crumbled into industrial ruins, she relies on her wits, strength, and practical skills to keep things running. Known for her iconic white top, tactical skirt, and heavy-duty boots, she is always ready to fix a broken generator or defend her community from scavengers. This model captures her standing confident and grounded amidst the industrial backdrop—a true everyday hero ready to bring grit and determination to your display shelf. Print Settings & Tips This model has been meticulously optimized for high-detail printing and is shown here beautifully hand-painted. Layer Height: 0.12 mm (Recommended for maximum detail. You can print at 0.20 mm to save time, but some of the finer surface textures and sharp details will be less pronounced at this scale). Model Height: 14 cm Infill: 8% Gyroid (Provides excellent structural strength while saving filament). Print Orientation: Print Upside Down! Printing the figure inverted significantly simplifies the support structure around the delicate fingers and ensures the facial and clothing details come out incredibly crisp and clean. CRITICAL SUPPORT REMOVAL & BED ADHESION ADVICE: Support Removal: To safely remove the supports without damaging the model, do not try to snip or tear them off completely in one go. Instead, clip them only halfway through to create a weak fracture point, then gently snap them away. Use a small flush cutter (side cutter) for precision work around tight areas. Bed Adhesion: Make sure your build plate is thoroughly cleaned (with isopropyl alcohol or warm dish soap) before starting. Good first-layer adhesion is vital since the model prints inverted. I would absolutely love to see your finished prints! Please share your makes and painted models in the comments section below!