Slicer Discord
Elevated Hex Coaster (for Draining / Drying) – 3D-printbaar model van MakerWorld MakerWorld
Other House Models

Elevated Hex Coaster (for Draining / Drying)

19 Downloads
10 Likes
13 Makes
Model downloaden
Coaster that provides maximum airflow to the bottom of your glass, helping the glass dry faster. Excess water can drip through the hexagon pattern. The lower tray catches the water and provides a large surface for it to evaporate off. I like to rinse and re-use a glass, so I place my glass on this after rinsing to prevent water stains from forming on my counter top. Prints in two pieces to avoid supports. To assemble, just slot the top piece slides into the bottom piece. Add a few drops of superglue to permanently attach them if desired. Leaving them un-glued makes it much easier to clean, if you care about that.
Categorie
Other House Models
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

Aptimex publiceert ook op

38 extra modellen op 2 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

3 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie