Elf Headphones

Elf on the Shelf headphones. These will fit your elf perfectly and print with no supports. I have been printing on the cool super tack plate with PLA Basic and some generic brand but Im sure this model will work on textured and other settings. Definitely a good pairing with the gaming chair and switch models that other users have posted! See image for size, I have made them slightly narrower than the width of the elf heads to ensure a snug fit that wont slip off. Merry Christmas MW Community!Edit 12/10/2025: Had a few people mention supports or glue were required for this print. I wouldnt recommend this. Print is intentionally simple and flat on build plate to avoid supports. Clean your plate and dry your filament. I just tested again on X1C with a BambuLab PLA Matte Black filament that was sitting in my AMS for over a week. Cleaned textured PEI plate with 99% IPA not even a warm soap wash. Results are shown in attached timelapse gif.