Thingiverse
Elliptical Rider Tread
von bbeaudoin
0
Downloads
1
Likes
0
Makes
UPDATE 1/4/2020: Just uploaded V2 which needs no glue or acetone.
This was made to replace the broken treads on my Ironman 420e Elliptical. I assume they could be modified to fit other models. My printer is too small to print this in one piece, so I printed each tread in 3 pieces (PLA) and used acetone to fuse them together (not V2).
This was made to replace the broken treads on my Ironman 420e Elliptical. I assume they could be modified to fit other models. My printer is too small to print this in one piece, so I printed each tread in 3 pieces (PLA) and used acetone to fuse them together (not V2).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!