Thingiverse
Elliptical Spinner
von Athruz
28
Downloads
16
Likes
0
Makes
Sort of a remix on another simple design I did. (http://www.thingiverse.com/thing:2206706)
Prints well and takes the standard bearings as the others.
Prints well in PETG and PLA
Caps from 2ROBOTGUY on his nice Tri Fidget Spinner Toy- I added a recess in the top for a finger pad. Big thanks and nice design (http://www.thingiverse.com/thing:1802260)
If you need some supplies:
Center Bearings: https://www.amazon.com/gp/product/B00VKK3I6W/ref=as_li_qf_sp_asin_il_tl?ie=UTF8&tag=athruz-20&camp=1789&creative=9325&linkCode=as2&creativeASIN=B00VKK3I6W&linkId=bcd4993a6b91494aa94ea79a48329a05
Bearings: (clean the grease out and use 1 to 2 small drops of the oil below works well. I remove the rubber outer seal and soak in 91% rubbing alcohol for 24 hours)
Outer Bearing: https://www.amazon.com/gp/product/B00VKK3I6W/ref=as_li_qf_sp_asin_il_tl?ie=UTF8&tag=athruz-20&camp=1789&creative=9325&linkCode=as2&creativeASIN=B00VKK3I6W&linkId=bcd4993a6b91494aa94ea79a48329a05 ($8.29 for 16
Prints well and takes the standard bearings as the others.
Prints well in PETG and PLA
Caps from 2ROBOTGUY on his nice Tri Fidget Spinner Toy- I added a recess in the top for a finger pad. Big thanks and nice design (http://www.thingiverse.com/thing:1802260)
If you need some supplies:
Center Bearings: https://www.amazon.com/gp/product/B00VKK3I6W/ref=as_li_qf_sp_asin_il_tl?ie=UTF8&tag=athruz-20&camp=1789&creative=9325&linkCode=as2&creativeASIN=B00VKK3I6W&linkId=bcd4993a6b91494aa94ea79a48329a05
Bearings: (clean the grease out and use 1 to 2 small drops of the oil below works well. I remove the rubber outer seal and soak in 91% rubbing alcohol for 24 hours)
Outer Bearing: https://www.amazon.com/gp/product/B00VKK3I6W/ref=as_li_qf_sp_asin_il_tl?ie=UTF8&tag=athruz-20&camp=1789&creative=9325&linkCode=as2&creativeASIN=B00VKK3I6W&linkId=bcd4993a6b91494aa94ea79a48329a05 ($8.29 for 16
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!