Elven Angst

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 4.6mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Basic Jade White Transmission Distance: 5PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Silver Transmission Distance: 0.5This print uses 5 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #8 (0.72mm) swap to RedAt layer #15 (1.28mm) swap to Jade WhiteAt layer #23 (1.92mm) swap to BlackAt layer #33 (2.72mm) swap to Blue GrayAt layer #41 (3.36mm) swap to SilverAt layer #46 (3.76mm) swap to Jade White for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider