Slicer Discord
Emergency Tums Container – 3D-printbaar model van MakerWorld MakerWorld
Other House Models

Emergency Tums Container

6 Downloads
2 Likes
0 Makes
Model downloaden
Now that I have a grand old time with some bad acid reflux, I find it necessary to keep a bottle of 1000mg Tums on me at all times. Sometimes it is inconvenient to keep a whole bottle on my person when I will most likely only need two tablets. That's why I made this container, it is minimalistic and can easily be kept in one's back pocket to keep two tums ready at a moment's notice. This is intended to be used with small 3mm diameter x 1.5mm deep neodymium magnets, which can be purchased cheap just about anywhere. Just use some super glue to hold em in place. I got mine here, which are uncommon on their website because it is a bulk surplus purchase, and they usually have imperial measurements only. http://www.kjmagnetics.com/proddetail.asp?prod=ZD4 1/8" x 1/16" is the closest imperial equivalent and should also work, may be a bit of a tighter squeeze but the tolerance of the hole diameter should still be good enough for that. So for anyone looking to make a smaller
Categorie
Other House Models
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
uitgebreide nabewerking
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 2/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Lijmen, Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie