Thingiverse
Enclosed Wind Generator Platform
von DigiDom
11
Downloads
8
Likes
0
Makes
This is an enclosed wind generator concept that should require only a few screws and some glue.
The base plate is designed to be replaceable, this is to allow for different alternator ideas / customization. Currently finishing the axial flux generator to go with the design. Any feedback is appreciated as this is a work in progress.
You will need to print
4x Base Shell
6x Outer shell statored passthrough
2 x Clip Top 1
2 x Clip Top 2
4 x Donut (optional)
1 x rest of the parts
additional Materials
8mm Diameter rod around 240mm in length
2x 22mm bearing (same the one used in skates)
Detailed instructions to be added later
The base plate is designed to be replaceable, this is to allow for different alternator ideas / customization. Currently finishing the axial flux generator to go with the design. Any feedback is appreciated as this is a work in progress.
You will need to print
4x Base Shell
6x Outer shell statored passthrough
2 x Clip Top 1
2 x Clip Top 2
4 x Donut (optional)
1 x rest of the parts
additional Materials
8mm Diameter rod around 240mm in length
2x 22mm bearing (same the one used in skates)
Detailed instructions to be added later
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!