Enclosure Access Slide Panel

Slide Access Panels for Enclosures Compiled and uploaded upon request from other Bambu Lab enthusiasts I heavily Modified these from small square wall grommets to larger sliding access panels for my greenhouse panel custom X1C enclosure. This allows you to slide open for filament switches and limited access to rear components. They are still on the smaller side, so are a bit tight. But they do help versus having to slide the printer out of the enclosure when needed access. The Expanded cover was created to allow added room if needed for the X1C buffer to operate if the enclosure size doesn't provide enough room. This may not be needed in your situation and the flat slide plate may suffice. There will be two separate series in the file. 1 - For single Filament Prints With lots of supports for some items. 2 - An additional set of plates for items that will be set to utilize a different support interface. Take note that the broad inside surface of the extended cover will be rough when usi