Enclosure Bow Clamp

I have an enclosure that I can vent to the outdoors but the top sags and sits right on the filament spools. I decided to remix the led light clamps (thing number 5593365) using Tinkercad. Only thing you need to purchase and cut to length would be a 3mm or 1/8"OD rod. I used a brass rod. What ever width your frame is then cut the rod about 2-3 inches so it will BOW up and hold the enclosure hood up above your filament spool.

I used Elegoo Rapid PLA+
Extruder temp 230C
Print bed temp 60C
Print speed of 400mm/s
I chose Fine print config in Cura 5.50 with Layer Height set at 0.2 using a 0.4 tip
Support is only inside the 3mm hole (it may print without supports though)
15% infill
With these settings I printed 2 of these in 20 minutes flat.
Just duplicate the first one on the build plate with your slicer.