Thingiverse
Enclosure door knob
door NZSpides
15
Downloads
11
Likes
0
Makes
This is a fairly basic door knob I created to hold a door closed on my Hypercube printer.
I wanted to keep the heat in and stable while printing ABS, and the Hypercube, having no sides, wasn't the best at keeping the heat in. So panels and a door were created.
I found hinges that worked for me, but no knob, so here it is in all it's primitive glory.
I used a M3 30mm bolt and a number of 3mm nuts. The outer knob has a nut to secure the bolt and lock it in place and stop it from turning. The inner has essentially the same arrangement. The last nut is a bit of a pain to do up though...
I wanted to keep the heat in and stable while printing ABS, and the Hypercube, having no sides, wasn't the best at keeping the heat in. So panels and a door were created.
I found hinges that worked for me, but no knob, so here it is in all it's primitive glory.
I used a M3 30mm bolt and a number of 3mm nuts. The outer knob has a nut to secure the bolt and lock it in place and stop it from turning. The inner has essentially the same arrangement. The last nut is a bit of a pain to do up though...
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
