Enclosure - FLSUN V400

This thing I give full credit to @Amazon62 at Printables.
To show him support please download from him. Link down below:

https://www.printables.com/model/329918-flsun-v400-enclosure-cover/files

I think this model is very useful and

Mounting(according to the creator):

1. Just slide the 2mm (max) acrylic plates in the 2 T-slots, which creates
a bended plate. Begin at the top and slide it carefully down. I used a
2mm 855x400 sheet, but the length is up to you. I like it to be flush
with the bottom of building plate and top of the printer.

2. Connect the 2 parts. Maybe it needs a bit of force (little tap of a
hammer). Put one side in the T-slot, lift the other half a bit up and
force it in the T-slot. You can also place the part seperately in the slots
and then connect them.

3. Slide the acrylic plate in the slot of the cover plate. Start at one side
and move towards the other side. Now place the top cover and slide
the whole