Thingiverse
Electronics
Zum Modell
Enclosure for proxmark3 easy
70
Downloads
45
Likes
0
Makes
This is an enclosure for the proxmark3 easy by Elechouse.
It is quite a tight fit, so you might need to resize it a bit depending on your filament shrinkage. I printed it in PLA and it was just the right size.
The parts are connected using tabs, no need for glue or screws.
It is quite a tight fit, so you might need to resize it a bit depending on your filament shrinkage. I printed it in PLA and it was just the right size.
The parts are connected using tabs, no need for glue or screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
