Enclosure-Ventialtion

I created a custom Fan-Mount for my Enclosure as the temperature was getting too hot (for PLA) when the doors were closed.
This design is optimized for a 120mm Filter (I used a ARCTIC P12 - 120 mm) and a 5mm activated-carbon filter.
ATTENTION: The Printer must be calibrated pretty good in Order to print this the right size, you might need to print it a little bit bigger than it is in order to fit in the fan.

Additional Items you need:
4x M4 screws (in my case they needed to be 50mm long) plus nuts

Instead of the ARCTIC P12 - 120 mm you can probably use any other 120mm fan (no guarantee)

For assembly just insert the nuts in the corresponding holes of the back, cut a hole (ino your enclosure-wall where you want the fan to be and also drill 4mm holes in the positions where the screw needs to pass through the wall, please ensure that the holes for the screws have enough material around them for stability purpose.

There is an extra hole in the front-side of the mount in ord