Thingiverse
End Fed Half Wave Antenna Case
door newsgroupmonkey
0
Downloads
0
Likes
0
Makes
This is a box for an End-Fed Half-Wave antenna.
Following Steve Ellington's 64:1 design, I used binding posts for both the ground and the long wire.
This uses standard Binding Posts as well as a Chassis Mount SO239.
Everything should be snug - the 4 holes around the SO239 fit the standard.
Everything uses M3 screws.
Following Steve Ellington's 64:1 design, I used binding posts for both the ground and the long wire.
This uses standard Binding Posts as well as a Chassis Mount SO239.
Everything should be snug - the 4 holes around the SO239 fit the standard.
Everything uses M3 screws.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!