Thingiverse
End Feed Shuttle with Pirn
di rvanhoutan
18
Download
13
Likes
0
Makes
This is an end feed shuttle with pirn.
I used brass wire to make the loops and hooks for the tensioner and super glued them in the holes.
Two of the hooks for the take-up and exit are formed in complete loops the rest can be simple hooks.
Supports are required as well as sanding to get a smooth finish.
The smaller the layer height, the better for the overhangs.
A double-ended bobbin winder is best used for winding the thread on the Pirn.
Use different hooks to route the thread in the tensioner to adjust the tension for your weaving.
I used brass wire to make the loops and hooks for the tensioner and super glued them in the holes.
Two of the hooks for the take-up and exit are formed in complete loops the rest can be simple hooks.
Supports are required as well as sanding to get a smooth finish.
The smaller the layer height, the better for the overhangs.
A double-ended bobbin winder is best used for winding the thread on the Pirn.
Use different hooks to route the thread in the tensioner to adjust the tension for your weaving.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
