Ender 2 Bed Strain Reliever

After printing a couple of strain reliever designs from the community, I found that they all ran into the Y-axis motor. With this design, I made the holder support the cable from above instead of below, and it clears the motor even when it has a damper.

There are two slots for zip-ties to support the cable and the holder itself is supported by two of the three bed springs.

I ended up having to adjust one of the belt ends on the bed because it runs into the holder when it's straight up. I just loosened the Y-axis and bent the little crimped end forward, which seems to clear the part just fine even when the belt is tightened back up.

Included is the .blend file I created for this.