Ender-2 LCD case

Update:
One person has complained about the LCD ribbon connector not fitting. I don't know why that is but I have added a post-processing picture to show how my connector just fits without interference. Please compare your parts before printing this enclosure.


This design is intended to set the Ender-2 LCD at an angle to make it more readable. I looked at other designs but couldn't find one that totally enclosed the electronics so I made this. I wanted to use the LCD screw holes in the original cover for mounting the new housing so this was achieved by designing the front and rear mounting bars.

Assembly:
4 self tapping screws into blind holes on the case underside are used to fix the LCD into the housing.
2 self tapping screws are used to hold the rear fixing bar to the original case from below.
2 self tapping screws are used to hold the front fixing bar to the original case from below.
The LCD case slides onto the the front bar.
2 self tapping screws are used to hol