Ender 2 mount for official Raspberry Pi Zero case

This is a mount I designed to attach the Raspberry Pi Zero in its original case to my Ender 2.

I have included 2 versions:

One attaches to the plate in front of the X stepper motor. This was my original idea and has the advantage that the camera view point moves upward with the print. However, I found the view from the side less than ideal, possibly due to the Petsfang parts cooler that obstructs a lot from the side.

I therefore designed a second version that slides into the nut on the lower half of the Y aluminium profile. This gives a nice view from the front.

The print in place hinge allows the Pi to be tilted back and forward for adjusting the viewing angle. I have designed that with .3mm tolerance. My print needed a bit of convincing (with a hammer) before it would move.

Both versions print without support.

I include the OpenSCAD source code. Be warned though, it's an ugly mess. ;)