Thingiverse
Ender 2 Pro LCD Stabilizer Bar
door wctt
5
Downloads
1
Likes
0
Makes
This is a simple bar to support the left side of the LCD panel since I didn't like how it was just floating. It also has holes to allow you to replace the M3 screws with longer screws if you want, but I found it actually snaps into place and stays there quite nicely.
Easily print on it's side with supports on the little nubs.
Edit: Added Right side and M3 screw holes to mount extra parts to the front. :)
It looks like the right side is actually lower than the left side for me, so probably just use the Left side is good.
Perhaps in the future, I can make that area into a little drawer.
Easily print on it's side with supports on the little nubs.
Edit: Added Right side and M3 screw holes to mount extra parts to the front. :)
It looks like the right side is actually lower than the left side for me, so probably just use the Left side is good.
Perhaps in the future, I can make that area into a little drawer.
wctt publiceert ook op
3 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
