Slicer Discord
Ender 3 Bed Handle – 3D-printbaar model van Thingiverse Thingiverse

Ender 3 Bed Handle

door AndyShap
84 Downloads
38 Likes
0 Makes
Model downloaden
I wanted a bed handle, but not one that used the bed leveling screws (I have enough trouble leveling the bed as it is without pulling on the screws all the time!).

I found the Ender-3 Minimal Bed Handle by McCynic
https://www.thingiverse.com/thing:3368115

I loved the minimalist design (I'm moving the bed, not driving a race car!) but this one was designed to use the bed leveler screws. I added a clamp which uses 2 M4 nuts and 2 M4x16mm bolts.

I used Cura to make the clamp end 100% infill so it is as strong as possible. (You could just print the whole thing with 100%) You should probably use PETG or ABS, but I'm not there yet.

You'll notice in the pictures, I stuck a little scrap shim between the screws and the bed frame as I didn't want to scratch my beautiful new Ender 3 V2!
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
ABS, PETG
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

AndyShap publiceert ook op

8 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie