Thingiverse
Ender 3 Bowden Wire Clip
por ADWWOOD
12
Descargas
6
Likes
0
Makes
This is a lightweight clip that can be used with the Ender 3 to secure the bowden tube and wires from the hotend to the extruder / controller.
The open hole should be occupied by the bowden tube and the two holes that have a cover should fit wiring from the system in the center and ABL wires on the far side.
Use a small drop of CA glue to hold the cover closed or some other type of glue.
Feel free to modify this as needed.
The open hole should be occupied by the bowden tube and the two holes that have a cover should fit wiring from the system in the center and ABL wires on the far side.
Use a small drop of CA glue to hold the cover closed or some other type of glue.
Feel free to modify this as needed.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!