Thingiverse
Ender 3 cable guide
by JimCnc
77
Downloads
45
Likes
0
Makes
Cable guide to keep the cables and the bowden tube together on the Ender 3.
I printed this in PLA, which works fine once it is installed. You can install it by twisting it around the cable and bowden tube. This is a bit finicky, unfortunately I snapped the end during installation. The model fits diagonally on the print bed of the Ender 3.
Update 2021/04/05:
As mentioned by maddmaxx308 in the comments; heating the model on your print bed before installing makes it more forgiving to install.
**Print settings:**
- max 0.2 mm resolution. I printed in 0.12 mm resolution
- 100% infill
- No support
- Material: PLA
I printed this in PLA, which works fine once it is installed. You can install it by twisting it around the cable and bowden tube. This is a bit finicky, unfortunately I snapped the end during installation. The model fits diagonally on the print bed of the Ender 3.
Update 2021/04/05:
As mentioned by maddmaxx308 in the comments; heating the model on your print bed before installing makes it more forgiving to install.
**Print settings:**
- max 0.2 mm resolution. I printed in 0.12 mm resolution
- 100% infill
- No support
- Material: PLA
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
