Ender 3 Control Box Height Offset
von RavenKillercam
27
Downloads
17
Likes
1
Makes
So recently I purchased a BL Touch Kit from amazon. However, The problem I ran into was that when I connected the adaptor for the BL-Touch into the motherboard, and connected the cables into the adapter, I then couldn't close the Electronics box.
I created this design to directly address that problem, and should work for others with the same issue.
NOTE:
• Offset = 1cm = 10mm
• Cannot Use The Same Factory Screws. (Longer M3 screws are needed)
• Some Fan Covers/Shrouds will not work with this design (some are too tall and will hit the bed wheels or the bed leveling screw)
I created this design to directly address that problem, and should work for others with the same issue.
NOTE:
• Offset = 1cm = 10mm
• Cannot Use The Same Factory Screws. (Longer M3 screws are needed)
• Some Fan Covers/Shrouds will not work with this design (some are too tall and will hit the bed wheels or the bed leveling screw)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
