![[Ender_3] Control box – 3D-Druckmodell von Thingiverse](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Fassets%2F6c%2Ff1%2F6f%2F25%2Fd7%2Flarge_display_SKR_1_4.JPG&w=800&h=800)
Thingiverse
[Ender_3] Control box
von i-alem
209
Downloads
141
Likes
2
Makes
Ender control box that will fit all the electronics.
Ideas and feedback are welcome. :D
Enjoy!
________________________________________________________________________
__Update:__
__04 Jan 2021:__
+ added a frame to mount the C3D 1.1.3 board and other bords with the same layout
+ touch upon the design -> better printable
__07 Jan 2021:__
+ added mounting points for two additional components [30 mm x 16 mm] on the left side cover
__22 Mar 2021:__
+ widened the PSU tray
+ added continues rail for better customizable future parts
+ adjusted the angle of the LCD screen (from 115° to 111,5°)
+ redesigned the circuit board for the SKR 1.4 and SKR MINI E3 (C3D_v.1.1.3 )
+ widened the port on the left panel for better access
________________________________________________________________________
__Parts needed for this Project:__
__Parts you already have:__
- 1 x LCD screen:
Cerality3D LCD (recomended: BTT TFT35 v3.0)
- 1 x Motherboard:
Ideas and feedback are welcome. :D
Enjoy!
________________________________________________________________________
__Update:__
__04 Jan 2021:__
+ added a frame to mount the C3D 1.1.3 board and other bords with the same layout
+ touch upon the design -> better printable
__07 Jan 2021:__
+ added mounting points for two additional components [30 mm x 16 mm] on the left side cover
__22 Mar 2021:__
+ widened the PSU tray
+ added continues rail for better customizable future parts
+ adjusted the angle of the LCD screen (from 115° to 111,5°)
+ redesigned the circuit board for the SKR 1.4 and SKR MINI E3 (C3D_v.1.1.3 )
+ widened the port on the left panel for better access
________________________________________________________________________
__Parts needed for this Project:__
__Parts you already have:__
- 1 x LCD screen:
Cerality3D LCD (recomended: BTT TFT35 v3.0)
- 1 x Motherboard:
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!