Ender 3 Enclosure

Simple enclosure for an Ender 3 or anything with similar dimensions

I used PETG but I suppose any filament would work. This is all designed around 2mm plexiglass and 13mm PVC (13mm inside diameter, 18mm outside)

(1) is the top corners. Print 4 ea
(2) is the middle for the sides, back, and top. Print 4 ea
(3) is an edge for the back, and top, Print 5 ea
(4) is a bottom edge for the back and sides. Print 3 ea
(5) is an edge for the front/top and front/bottom. Print 2 ea
(6) is an edge for the front sides. Print 2 ea
(7) is the bottom corners. Print 4 ea.

Should be a total of 24 pieces. My first draft of these components used exact measurements and I found that it was somewhat difficult to assemble without breaking some of the pieces. Gorilla glue seems to hold them back together but I decided to modify my original designs to add about .5mm clearance for the plexiglass and 1mm for the PVC. I also increased the thickness of the tabs slightly to accomodate.

All