Thingiverse
Ender 3 / Ender 3 Pro Pi Camera mount
von cg2112
7
Downloads
3
Likes
0
Makes
This thing is inspired by this thing:
https://www.thingiverse.com/thing:3147295
I liked the look of the bracket, but I wanted to mount it higher, as it obscured my view of the LCD. Additionally, the slot for the camera ribbon cable wasn't wide enough.
This mount will only work with the Ender 3/Ender 3 Pro that does NOT have a nut for the pulley on right of the x-axis.
I'm using this case for the camera, as most fully enclosed cases I've found are too tight for my liking:
https://www.thingiverse.com/thing:4446024
(I drop my camera in upside down to make it more accessible/removable)
Additionally, there are slots for to micro-USB cards and a USB/micro-USB adapter.
Supports aren't needed, though you might want them - the area around the M3 bolt is 90 degrees and might be a little messy without (see my photo)
https://www.thingiverse.com/thing:3147295
I liked the look of the bracket, but I wanted to mount it higher, as it obscured my view of the LCD. Additionally, the slot for the camera ribbon cable wasn't wide enough.
This mount will only work with the Ender 3/Ender 3 Pro that does NOT have a nut for the pulley on right of the x-axis.
I'm using this case for the camera, as most fully enclosed cases I've found are too tight for my liking:
https://www.thingiverse.com/thing:4446024
(I drop my camera in upside down to make it more accessible/removable)
Additionally, there are slots for to micro-USB cards and a USB/micro-USB adapter.
Supports aren't needed, though you might want them - the area around the M3 bolt is 90 degrees and might be a little messy without (see my photo)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
