Thingiverse
Ender 3 Filament Guide
by gareth8118
1
Downloads
0
Likes
0
Makes
Filament guide for the Ender 3 Pro.
I could not get a 608 bearing ontom nor an M3 bolt into the original model, so I reduced the OD of the peg for the bearing from 7.99mm to 7.88mm, and I created a hole for an M3 brass insert for the retainer. Pulley half and retainer both are unchanged from the original.
I could not get a 608 bearing ontom nor an M3 bolt into the original model, so I reduced the OD of the peg for the bearing from 7.99mm to 7.88mm, and I created a hole for an M3 brass insert for the retainer. Pulley half and retainer both are unchanged from the original.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
