Ender-3 Guide Filament

This is my version of the filament guide made by @Morley

Added A bearing version for the guide wheels

Nozzle diameter : 0.4

Support : Yes

ICE "Obstinate Orange"

Layer Height : 0.15 mm

Nozzle Temp : 200°C

Bed Temp : 60°C

Speed : 60 mm/s

Note : After print it may be necessary to break the rollers with gentle force using some small skrewdriver.

Note Note : Just after posting this design on the site, I've discovered that this design was already used by @BomZilla , But it's not a remak of his "Better 3D Printable Bearing" (https://www.thingiverse.com/thing:2746804) . The fun thing is, we both start from a design from @bribro12 (https://www.thingiverse.com/thing:2349065) and as the issue he had , on smaller bearings, the rollers twisted out of place and jammed up. And the same problem give the same result. But this design is not a remake, just two guys with the same problem and the same connection in there brains :)