Ender 3 Hot End Connector Bracket

I wanted to be able to easily swap out the hot end on my Ender3 Printers so that I could rebuild them off of the printer. I converted the heating element to use a mini tamiya connector and then used a jst xh extension for the thermistor. This bracket holds both connectors snugly and mounts to the extrusion using a single screw. Below are the parts that I purchased from Amazon: Mini Tamiya Connector:https://www.amazon.com/dp/B00XQ91998?ref=ppx_yo2ov_dt_b_fed_asin_title JST XH extension:https://www.amazon.com/dp/B09BN67SZ8?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1 For the mini Tamiya connector that goes to the control board, I used some 18 awg wire I had laying around and crimped and soldered the terminals to it. The other end of the wires just go into the screw terminals on the board. I assembled the connector before putting it into the bracket. On the heating element end, I also crimped and soldered the terminals to it and then assembled the connector.For the JST connection, the connector