Thingiverse
Ender 3 indicator holder v2
von Nico42350
58
Downloads
38
Likes
0
Makes
Modify the holes to setup the height of the indicator.
Perfect the air flux for the fan.
Use a drill diam. 8mm to perfect the indicator hole.
In my case, I prefer remove the indicator for printing.
Compatible for CR10, Tornado ...
Enjoy ;)
Perfect the air flux for the fan.
Use a drill diam. 8mm to perfect the indicator hole.
In my case, I prefer remove the indicator for printing.
Compatible for CR10, Tornado ...
Enjoy ;)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
