Thingiverse
Ender 3 Klicky Probe
by dak2007
8
Downloads
4
Likes
0
Makes
This is a klicky probe for the Ender 3 V2. I was heavily inspired by the KlackEnder by KevinAkaSam (https://github.com/kevinakasam/KlackEnder-Probe).
My printer has linear rails which prevented the KlackEnder from working with my setup. Also, I was unable to get consistent results with only 2 magnets and found 3 to be far better. This design is based on the UniTak3d Direct Drive Upgrade kit. It could work with other's but I am not sure.
To assemble I used a M5 bolt through the carriage and X Axis Mount with a nut on the mount side. This prevents the mount from moving and greatly increases the accuracy of the probe. The Holder uses M5 bolts/T-nuts and mounts to the right gantry.
It is a tight fit and you may need to take a file to some areas.
The probe/mount uses 6ea 6x3mm magnets. I prefer to solder directly to the magnets and have not noticed a reduction in their performance. I set it up where the 2 magnets making the electrical connection are facing the same way
My printer has linear rails which prevented the KlackEnder from working with my setup. Also, I was unable to get consistent results with only 2 magnets and found 3 to be far better. This design is based on the UniTak3d Direct Drive Upgrade kit. It could work with other's but I am not sure.
To assemble I used a M5 bolt through the carriage and X Axis Mount with a nut on the mount side. This prevents the mount from moving and greatly increases the accuracy of the probe. The Holder uses M5 bolts/T-nuts and mounts to the right gantry.
It is a tight fit and you may need to take a file to some areas.
The probe/mount uses 6ea 6x3mm magnets. I prefer to solder directly to the magnets and have not noticed a reduction in their performance. I set it up where the 2 magnets making the electrical connection are facing the same way
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
