Ender 3 LED light bar mount

The original brackets by RogueGeek had more of an angle then I wanted. Great basis for this design. I decided I wanted 2 lights, up as high as possible in case of tall prints. I wanted to have 2 brackets that would hold both the lights. Wired them together, added a 2amp fuse and wired directly to the power supply.

I have a file for a single light (print 2 brackets)
The other file is for the double (print 2 brackets)

Brackets slide around a bit, might vary depending on how everyones printers are dialed...

These were the lights I used for this project https://www.amazon.com/dp/B08B5T4STX?psc=1&ref=ppx_yo2ov_dt_b_product_details

And the parts I ordered to complete this:

https://www.amazon.com/dp/B09JW4KPKW?psc=1&ref=ppx_yo2ov_dt_b_product_details
https://www.amazon.com/dp/B07MBWKX53?psc=1&ref=ppx_yo2ov_dt_b_product_details
https://www.amazon.com/dp/B07S33YTKY?psc=1&ref=ppx_yo2ov_dt_b_product_details

I am no master designer, this may not be perfect, and if I make any