Thingiverse
Ender 3 MAX Leveling test
von jinx88
352
Downloads
195
Likes
0
Makes
simple g-code i use to level test my ender 3 max
single layer disks with skirt
no fancy code done to pause print to test it i adjust on the fly while the initial skirt is placed then fine tune at each individual disk.
helps to run the print a second time just for the skirt to verify additional adjustments done havnt disrupted other corners
uploaded because theyre isnt any level tests out there i could find for my ender 3 max
single layer disks with skirt
no fancy code done to pause print to test it i adjust on the fly while the initial skirt is placed then fine tune at each individual disk.
helps to run the print a second time just for the skirt to verify additional adjustments done havnt disrupted other corners
uploaded because theyre isnt any level tests out there i could find for my ender 3 max
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
