Thingiverse
Ender 3 Max power supply Relocation
por Hook3D
267
Descargas
145
Likes
1
Makes
UPDATED: power mount, noticed the STL didn't translate properly, all fixed
this is to relocate the PSU for the ender 3 max for a dual z install
no supports needed
power mount is printed from the face that contains the mount for the power plug
End piece 1 is printed from the flattest edge face standing up
a 5mm brim was used
Esun PLA+
0.2mm layers
25% triangle infill
this is to relocate the PSU for the ender 3 max for a dual z install
no supports needed
power mount is printed from the face that contains the mount for the power plug
End piece 1 is printed from the flattest edge face standing up
a 5mm brim was used
Esun PLA+
0.2mm layers
25% triangle infill
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
