Thingiverse
Ender 3 Max Spool holder Clip
door Kstank
0
Downloads
2
Likes
1
Makes
both for the 2020 aluminum rails and the 4040 rails
print on one side and use supports
You'll need a heat insert nut for the one side to properly thread and tighten to existing spool holder
-----------------
June 20, 2022
-Added a 2020 vertical mount to file will need a heat insert nut and recommended to T-Nut it to frame. It has enough room to easily snap into place and hold and can be slid on/off if required
print on one side and use supports
You'll need a heat insert nut for the one side to properly thread and tighten to existing spool holder
-----------------
June 20, 2022
-Added a 2020 vertical mount to file will need a heat insert nut and recommended to T-Nut it to frame. It has enough room to easily snap into place and hold and can be slid on/off if required
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!