Ender 3 Nozzle Brush

This is not my idea, but wiping the nozzle before every print clearly helps to have a better first layer. Especially when you have thin lines like the one in the video.
Buy a brass brush, cut it like in the picture and use double-sided tape to attach it to the bracket.
To attach the bracket to the bed, you don't need to disassemble the bed. Just slide the bracket between the bed and the knob and it should clip into place, with a little pressure. If your printer has a different calibration than mine, and the fit is too tight, you can trim or cut a bit the press fit.
There are other versions around, which lock in the knob, but when you heat the bed, heat is passed to the bracket and the bracket tends to melt or bend with time.

You have to tune your x-stop switch and homing info to make sure that the nozzle can reach the brush. Or do like I did, and change the firmware to set the x size of the bed 250mm instead of 235. then you have to configure your slicer so that in the Start G-Co