Ender 3 Power supply (PSU) relocation - extra secure

After dual-Z upgrade for my Ender-3 (non-pro), I wanted to move the PSU.


Tried few existing designs, but all had some downfalls, so remixed this to make is secure.


https://www.thingiverse.com/thing:3304804 - This slides into extrusions and does not have any T-nuts to secure, so its wobbly.

https://www.thingiverse.com/thing:3580914 - This has the holes needed to secure both horizontally and vertically, but it thin and wobbly without the slanted supports.

This design is remixed from both to add screw holes for both vertical & horizontal.

You will need T-nuts and M4 and/or M3 screws.