Ender 3 (pro) cable clip

This is a clean cable holder that mounts to the z-axis motor of a ender 3 (pro). There are a couple of different versions available, depending on the tickness of the ring and the prefferd lenght of the screw. These prints are tested in PLA and it is flexible enough to fit the cables through. The 2 mm or 3 mm at the end of the file name refers to the tickness of the clip. The 2mm is a bit more flexible and therefore easier to install, whilst the 3mm thick parts may be a bit stronger.

I did get the idea of using the threads in the z-axis motor from Saitrix (https://www.thingiverse.com/thing:2949858), but this design was made by me. So apart from mounting location, it is completly designed and thought of by me.

If you want to use two M3x12 screws, select one of the following:
- z axis cable mangement m3x12 2mm
- z axis cable mangement m3x12 3mm

The 2 mm will be easier to install, but the 3mm might be stronger.

If you want to use two M3x10 screws, select one of the following: