Ender 3 Pro Damper Spacers

This is a remix of the damper spacer by matthijsp (https://www.thingiverse.com/thing:3245255), designed for the Ender 3 Pro. You only need to print the one file provided in this remix for the printer and you can re-use most of the original Ender 3 Pro hardware.

__You will need the following additional hardware:__
2x M3x25mm screws*
2x M3 nuts
2x M3 washers (optional)

**Longer screws are possible, but you will need to space them using M3 nuts and/or washers (see my pictures)*

1. Switch off and electrically disconnect Ender 3 Pro

2. Disconnect X and Y axis stepper motors and limit switches

3. Remove screws holding X and Y axis stepper motors (take care not to drop them)

__NOTE: Set aside all screws for reassembly__

4. Attach stepper dampers as per image with the original M3x6mm screws

__NOTE: Swap stepper dampers so that the X axis motor goes on the Y axis and vice versa__

5. Attach X and Y axis dampers as shown, using the M3x25mm screws and nuts to