Thingiverse
Ender 3 Pro Lower Cable Guide
von DPS_Design
4
Downloads
1
Likes
0
Makes
After mounting all my Ender's electronics remotely, the cable pass-thru is too good to pass up for my Pi camera cable - but not with those sharp edges.
I beveled all edges the cable will touch, so cables slide very easily. -My camera cable slides through with the bed moving on the Y axis.
I beveled all edges the cable will touch, so cables slide very easily. -My camera cable slides through with the bed moving on the Y axis.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
