Thingiverse
Ender 3 Pro Pi Camera Mount
von Fonseca1015
8
Downloads
2
Likes
1
Makes
I wanted a mount at the end of the bed for my Pi camera to make some time lapses. There are two cases for the pi camera, one is for the stock camera, the other has a wider opening for the wide lens. Both will work with the stock camera. It is all held together with 3mm screws. I wanted it to be sturdy and attached to the end of the bed so I drilled holes to screw it in place.
I threw together a swivel mount for the camera, mine points a tiny bit to the left. I haven't printed it yet so not sure how well it will work.
I also added a rail mount, meant to go on the left rail next to the bed. There are also some different attachments to give it more movement when on the rail, you can just mix and match pieces. The rail piece should be printed as is with build plate supports.
I threw together a swivel mount for the camera, mine points a tiny bit to the left. I haven't printed it yet so not sure how well it will work.
I also added a rail mount, meant to go on the left rail next to the bed. There are also some different attachments to give it more movement when on the rail, you can just mix and match pieces. The rail piece should be printed as is with build plate supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
