Thingiverse
Ender 3 Pro Power Relocation
door Smyffe
8
Downloads
9
Likes
0
Makes
This is a relocation of the power unit for a ender 3 pro purchased after or around July 2021
i have also added a cable chain mount that suits Johnniewiskey's chains https://www.thingiverse.com/thing:2920060
Uses original screws from power box, NO extra screws needed,
overtime i will be updating this, any suggestions feel free to leave a comment.
i am planning on making a rear exit and right side exit cable versions too
---------------------------------------------------------------------------------------------------------------------
Print Temp: 185
Bed Temp: 55
Supports: Tree Supports @10degrees supporting anything over 70degrees
Slicer: Cura
I recommend printing these with the smallest flat surface on the bed
i have also added a cable chain mount that suits Johnniewiskey's chains https://www.thingiverse.com/thing:2920060
Uses original screws from power box, NO extra screws needed,
overtime i will be updating this, any suggestions feel free to leave a comment.
i am planning on making a rear exit and right side exit cable versions too
---------------------------------------------------------------------------------------------------------------------
Print Temp: 185
Bed Temp: 55
Supports: Tree Supports @10degrees supporting anything over 70degrees
Slicer: Cura
I recommend printing these with the smallest flat surface on the bed
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
