Thingiverse
Ender 3 Pro Raspberry Pi Camera Mount
door Urstad
25
Downloads
19
Likes
0
Makes
This mount is based on the "Ender 3 Camera Mount for Raspberry Pi Camera V2.1"
by Codemonkey1973.
**A CR-Touch just clears on my Ender 3 Pro but check your clearances to be sure.**
Camera is possibly OV5647 NoIR (or similiar), with a wide angle lens that i found on Aliexpress.
The camera PCB is W=25mm H=24mm and the housing allows for 6.5mm tick cameras.
The cable goes in thru a slot in the bottom of the housing and the bracket clips on
to the X-stepper cover. STEP file is included if there is a need for change.
Screws and nuts used,
2x MC6S M3x14 ISO 4762 / DIN 912 socket head screw (design allows for up to 18mm).
2x M6LM M3 DIN 985 Nyloc Nut.
Alternatively (depending on bracket choice),
1x M6LM M3 DIN 985 Nyloc nut (not really needed, standard nut can be used).
1x M6M M3 DIN 934 Nut.
by Codemonkey1973.
**A CR-Touch just clears on my Ender 3 Pro but check your clearances to be sure.**
Camera is possibly OV5647 NoIR (or similiar), with a wide angle lens that i found on Aliexpress.
The camera PCB is W=25mm H=24mm and the housing allows for 6.5mm tick cameras.
The cable goes in thru a slot in the bottom of the housing and the bracket clips on
to the X-stepper cover. STEP file is included if there is a need for change.
Screws and nuts used,
2x MC6S M3x14 ISO 4762 / DIN 912 socket head screw (design allows for up to 18mm).
2x M6LM M3 DIN 985 Nyloc Nut.
Alternatively (depending on bracket choice),
1x M6LM M3 DIN 985 Nyloc nut (not really needed, standard nut can be used).
1x M6M M3 DIN 934 Nut.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
